Distributor:
Rep / Salesperson:
Name:
City / State:
E-mail*:
Phone*:
Fax To*:
1) Material Being Machined:    If specific material is not known, what type: Aluminum Copper Alloys Cast Iron Low Carbon Steel Medium Strength Steel High Strength Steel High Temperature Alloys Hardness:	2) Specific Tool Styles: Reamer Spiral Fluted Drill Coolant Reamer Die Drill End Mill      Peripheral      Slotting Coolant Drill Arbor Mounted Cutter Counterbore Other:
3) Currently Using:    Carbide Tipped    Solid Carbide    High Speed Number of Flutes or Teeth: Type of Coating: Please Indicate Manufacturer's Tool Number If Known:	4) Application Information: Tool Size: Depth of Hole: Stock Removal: Type of Hole: Blind Thru Bushing Being Used? Yes No Tool Holder Fixed Floating Interrupted Cut (Keyways, Crossholes, etc.)? Yes No
5) Speed:     (Surface Feet Per Minute or RPM)     Feed Rate:     (Inch Per Rev. Or Inch Per Minute)	6) Chip Load Per Tooth:    Current Number of Parts Per Tool:
7) Coolant or Cutting Oil Being Used:    Yes No	8) Fixturing or Holding Method:    Non-Rigid Rigid Very Rigid
9) Additional Information or Comments: